Store Page = http://store.digilentinc.com/arty-board-artix-7-fpga-development-board-for-makers-and-hobbyists/ | Manual = [[reference-manual]] | Support = https://forum.digilentinc.com/forum/4-fpga/ | Title = Arty | Subtitle = Artix-7 FPGA Development Board | Header = Features | Bullet = Programmable over JTAG and Quad-SPI Flash | Bullet = On-chip analog-to-digital converter | Header = Key Specifications | FPGA Part # = XC7A35TICSG324-1L | Logic Slices = 5,200 | Block RAM = 1,800 Kbits | DSP Slices = 90 | DDR3 = 256 MB @ 667 MHz | Internal clock = 450 MHz+ | Quad-SPI Flash = 16 MB | Ethernet = 10/100 Mbps | Header = Connectivity and Onboard I/O | Pmod Connectors = 4 | Shield Connector = Arduino / chipKIT compatible | Switches = 4 | Buttons = 4 | Reset LED = 1 | User LED = 4 | User RGB LED = 4 | Header = Electrical | Power = USB \\ 7-15v (2.5mm coaxial) supply | Logic Level = 3.3v | Header = Physical | Width = 3.4 in | Length = 4.3 in
This page was created for the original Arty board, revisions A-C. The Arty has since been replaced by the Arty A7. See the Arty A7 Resource Center for up-to-date materials.
Arty is a ready-to-use development platform designed around the Artix-7™ Field Programmable Gate Array (FPGA) from Xilinx. It was designed specifically for use as a MicroBlaze Soft Processing System. When used in this context, Arty becomes the most flexible processing platform you could hope to add to your collection, capable of adapting to whatever your project requires. Unlike other Single Board Computers, Arty isn't bound to a single set of processing peripherals: One moment it's a communication powerhouse chock-full of UARTs, SPIs, IICs, and an Ethernet MAC, and the next it's a meticulous timekeeper with a dozen 32-bit timers.
- Arty - Getting Started with Microblaze Servers
- Arty Programming Guide
- Getting Started with ARTY's Base System Design
- Getting Started with Digilent Pmod IPs
- Getting Started with the Vivado IP Integrator
- Getting Started with Vivado
- How To Store Your SDK Project in SPI Flash
- Installing Vivado and Digilent Board Files
- Programming Digilent FPGA Boards Through Multisim
There was an error communicating with Hackster. The HTTP request returned an error of 429
- Avnet Product Brief - REQUIRES REGISTRATION