Nexys 4 DDR GPIO Demo
The Basic User Demo project demonstrates a simple use of the Nexys4-DDR's GPIOs and UART port. The behavior is as follows:
- The 16 User LEDs are tied to the 16 User Switches.
- The 7-Segment display counts from 0 to 9 on each of its 8 digits. Also, single anodes of the 7-Segment display are blanked by holding BTNU, BTNL, BTND, or BTNR. Holding the center button blanks all the 7-Segment anodes.
- An introduction message is sent across the UART when the device is finished being configured.
- A message is sent over UART whenever BTNU, BTNL, BTND, or BTNR is pressed.
- The Tri-Color LEDs cycle through several colors in a ~4 second loop.
- Data from the microphone is collected and transmitted over the mono audio out port.
- The demo is reset whenever BTNC is pressed.
|16 user switches||X|
|16 user LEDs||X|
|Two tri-color LEDs||X|
|5 User Push Buttons||X|
|Two 4-digit 7-segment displays||X|
|4 Pmod ports||X|
|Pmod for XADC signals||X|
|12-bit VGA output||X|
|Serial Flash for Application Data||X|
|USB HID Host With Mouse||X|
|USB HID Host With Keyboard||X|
|Micro SD card connector||X|
|PWM audio output||X|
|10/100 Ethernet PHY||X|
- Nexys 4 DDR FPGA board
- Micro-USB cable
- Set of headphones or a speaker
- Vivado Design Suite 2016.4
- Newer versions can be used, but the procedure may vary slightly
- Nexys 4 DDR Support Files
- These files will describe GPIO interfaces on your board and make it easier to select your FPGA board and add GPIO IP blocks.
- Follow the Wiki guide: Vivado Board Files for Digilent 7-Series FPGA Boards on how to install Board Support Files for
Download and Launch the Nexys 4 DDR Basic User Demo
1) Follow the Using Digilent Github Demo Projects Tutorial. This is an HDL design project, and as such does not support Vivado SDK, select the tutorial options appropriate for a Vivado-only design. Return to this guide when prompted to check for extra hardware requirements and setup.
2) In order to fully use the demo, you will need to connect a serial terminal to your Nexys DDR. Plug your board into your computer with Micro USB cables attached to the PROG+UART port and make sure the board is turned on. Then open a serial terminal (such as TeraTerm) on your computer. In the terminal application, setup the serial port to connect to the appropriate port for your board, with a baud rate of 9600. Then return to the Github Projects Tutorial to finish programming and running the demo.
Using the Nexys 4 DDR Basic User Demo
1. Switches and LEDs
2. Seven Segment Display
3. Tri-Color LEDs
The two tri-color LEDs are set to gradually change colors at all times. The user cannot affect them in this demonstration.