Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| dmc-60c:hardware-reference-manual [2019/01/11 18:53] – [5 Brake / Coast Mode] Thomas Kappenman | dmc-60c:hardware-reference-manual [2019/01/11 18:54] – [6 Input Signal Calibration] Thomas Kappenman | ||
|---|---|---|---|
| Line 123: | Line 123: | ||
| To perform calibration, | To perform calibration, | ||
| - | * 1. Press and hold the Brake / CAL button. After approximately 5 seconds, the top and bottom LEDs will begin to alternate between Blue and Off. This indicates that calibration has started. | + | * 1. Press and hold the Brake/Coast CAL button. After approximately 5 seconds, the top and bottom LEDs will begin to alternate between Blue and Off. This indicates that calibration has started. |
| * 2. While continuing to hold the button, use the controller to move between full forward and full reverse (perhaps by moving a joystick), making sure to reach both extremes. This may be repeated more than once, but there is no required minimum. | * 2. While continuing to hold the button, use the controller to move between full forward and full reverse (perhaps by moving a joystick), making sure to reach both extremes. This may be repeated more than once, but there is no required minimum. | ||
| * 3. Return the controller to neutral (return the joystick to the neutral position). | * 3. Return the controller to neutral (return the joystick to the neutral position). | ||
| - | * 4. Release the Brake / CAL button. | + | * 4. Release the Brake/Coast CAL button. |
| * 5. If calibration was successful, then the top and bottom LEDs will quickly alternate between Green and Off and the new calibration constants will be stored in non-volatile memory. If calibration failed, then the top and bottom LEDs will quickly alternate between Red and Off and the device will continue to operate using the existing calibration constants. | * 5. If calibration was successful, then the top and bottom LEDs will quickly alternate between Green and Off and the new calibration constants will be stored in non-volatile memory. If calibration failed, then the top and bottom LEDs will quickly alternate between Red and Off and the device will continue to operate using the existing calibration constants. | ||
| Line 133: | Line 133: | ||
| To restore default calibration: | To restore default calibration: | ||
| * 1. Disconnect the power source from the DMC60C. | * 1. Disconnect the power source from the DMC60C. | ||
| - | * 2. Hold the Brake / CAL button down. | + | * 2. Hold the Brake/Coast CAL button down. |
| * 3. While continuing to hold the button, apply power to the DMC60C. | * 3. While continuing to hold the button, apply power to the DMC60C. | ||
| * 4. Continue holding down the button until the top and bottom LEDs alternate quickly between Green and Off. | * 4. Continue holding down the button until the top and bottom LEDs alternate quickly between Green and Off. | ||
| - | * 5. Release the Brake / CAL button. | + | * 5. Release the Brake/Coast CAL button. |
| **Note:** //This will also restore all DMC60C settings to their factory default state.// | **Note:** //This will also restore all DMC60C settings to their factory default state.// | ||