Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
dmc-60c:getting-started [2018/08/08 20:47] – [Prerequisites] Thomas Kappenman | dmc-60c:getting-started [2018/08/08 21:09] – Thomas Kappenman | ||
---|---|---|---|
Line 31: | Line 31: | ||
>1.1) Power up the roboRIO and plug it into your network via ethernet cable, or into the computer via USB. | >1.1) Power up the roboRIO and plug it into your network via ethernet cable, or into the computer via USB. | ||
- | > | + | >1.2) Open **roboRIO Imaging Tool**. **Find** the roboRIO in the roboRIO Targets box. |
> | > | ||
> | > | ||
Line 43: | Line 43: | ||
====2. Installing DMC60C Library files ==== | ====2. Installing DMC60C Library files ==== | ||
- | >2.1) Run **Copy files to wpilib and roboRIO.bat** and enter the IP address of the roboRIO. This batch file will copy the DMC60C Library files to the WPILib directory, and to the roboRIO' | + | >2.1) Run **Copy files to wpilib and roboRIO.bat** and enter your team number. This batch file will copy the DMC60C Library files to the WPILib directory, and to the roboRIO' |
> | > | ||
>2.2) You may get the following message describing a potential security breach. You may disregard this message and press ' | >2.2) You may get the following message describing a potential security breach. You may disregard this message and press ' | ||
> | > | ||
> | > | ||
+ | |||
+ | ====3. Configuring your DMC60C ==== | ||
+ | >3.1) Open an internet browser and type " | ||
+ | > | ||
+ | >3.2) If the DMC60C configuration utility was successfully set up, it will show up in the browser. Make sure to change the device ID from 0 to any number between 1 and 65 before continuing. You may also configure any other options here as well. | ||
+ | > | ||
+ | > | ||
====3. Opening an example project ==== | ====3. Opening an example project ==== |