Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| vivado:getting-started-with-ipi:start [2019/10/31 21:23] – Arthur Brown | vivado:getting-started-with-ipi:start [2020/03/09 18:59] – [4. Create a Simple Block Design] Arthur Brown | ||
|---|---|---|---|
| Line 315: | Line 315: | ||
| Click **Run Block Automation** in the green bar at the top of the screen. This will launch a dialog that allows initial configuration of the Zynq block. | Click **Run Block Automation** in the green bar at the top of the screen. This will launch a dialog that allows initial configuration of the Zynq block. | ||
| - | In the Run Block Automation dialog, make sure that **FIXME** under **All Automation** in the panel to the left is selected and checked. | + | In the Run Block Automation dialog, make sure that **Apply Board preset** under **All Automation** in the panel to the left is checked. |
| There are a number of different options available. For the purposes of this guide, set these options to the value found in parentheses below. | There are a number of different options available. For the purposes of this guide, set these options to the value found in parentheses below. | ||