Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| vivado:getting-started-with-ipi:start [2019/03/29 19:57] – [4. Create a Simple Block Design] James Colvin | vivado:getting-started-with-ipi:start [2020/04/23 22:16] – James Colvin | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Getting Started with the Vivado IP Integrator ====== | + | ====== Getting Started with Vivado IP Integrator ====== |
| + | |||
| + | <WRAP center round important 60%> | ||
| + | This guide uses 2016.4. An updated version of this guide for 2018.2 can be found [[/ | ||
| + | </ | ||
| /*FIXME: images should be collected into the correct namespace (yay)*/ | /*FIXME: images should be collected into the correct namespace (yay)*/ | ||
| Line 315: | Line 320: | ||
| Click **Run Block Automation** in the green bar at the top of the screen. This will launch a dialog that allows initial configuration of the Zynq block. | Click **Run Block Automation** in the green bar at the top of the screen. This will launch a dialog that allows initial configuration of the Zynq block. | ||
| - | In the Run Block Automation dialog, make sure that **FIXME** under **All Automation** in the panel to the left is selected and checked. | + | In the Run Block Automation dialog, make sure that **Apply Board preset** under **All Automation** in the panel to the left is checked. |
| There are a number of different options available. For the purposes of this guide, set these options to the value found in parentheses below. | There are a number of different options available. For the purposes of this guide, set these options to the value found in parentheses below. | ||