Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
vivado:getting-started-with-ipi:start [2019/03/29 19:57] – [4. Create a Simple Block Design] James Colvinvivado:getting-started-with-ipi:start [2020/03/09 18:59] – [4. Create a Simple Block Design] Arthur Brown
Line 1: Line 1:
-====== Getting Started with the Vivado IP Integrator ======+====== Getting Started with Vivado IP Integrator ======
  
 /*FIXME: images should be collected into the correct namespace (yay)*/ /*FIXME: images should be collected into the correct namespace (yay)*/
Line 315: Line 315:
 Click **Run Block Automation** in the green bar at the top of the screen. This will launch a dialog that allows initial configuration of the Zynq block. Click **Run Block Automation** in the green bar at the top of the screen. This will launch a dialog that allows initial configuration of the Zynq block.
  
-In the Run Block Automation dialog, make sure that **FIXME** under **All Automation** in the panel to the left is selected and checked.+In the Run Block Automation dialog, make sure that **Apply Board preset** under **All Automation** in the panel to the left is checked.
  
 There are a number of different options available. For the purposes of this guide, set these options to the value found in parentheses below. There are a number of different options available. For the purposes of this guide, set these options to the value found in parentheses below.