Zybo

Store Reference Manual Technical Support
Zybo
Zynq-7000 ARM/FPGA SoC Trainer Board
Features
  • On-board JTAG programming and UART to USB converter
  • On-chip analog-to-digital converter
Key Specifications
Logic Cells
4,400 logic slices
(4 6-input LUTs and 8 flip-flops)
Block RAM
240 KB
DSP Slices
80
DDR3
512 MB w/ 1050Mbps bandwidth
Internal clock
450 MHz+
Ethernet
Trimode (1Gbit/100Mbit/10Mbit)
Connectivity and On-board I/O
Pmod Connectors
6 Pmod ports
Audio
Audio codec with headphone out,
microphone, and line in jacks
USB
USB 2.0 (supports host & device)
SD
MicroSD card slot
VGA
16-bit VGA port
HDMI
Dual-role (source/sink) port
Switches
4
Buttons
6
LEDs
5
Electrical
Power
USB, wall wart with barrel jack,
and battery pack
Logic Level
3.3V
Physical
Width
3.3 in
Length
4.8 in
Design Resources
SDSoC Video I/O Platform
Master XDC
Zynq Preset
Petalinux BSP
Zybo Base System Design
Documentation
Primary IC
Zynq-7000
(XC7Z010-1CLG400C)
Reference Manual
Schematic

The ZYBO (ZYnq BOard) is a feature-rich, ready-to-use, entry-level embedded software and digital circuit development platform built around the smallest member of the Xilinx Zynq-7000 family, the Z-7010. The Z-7010 is based on the Xilinx All Programmable System-on-Chip (AP SoC) architecture, which tightly integrates a dual-core ARM Cortex-A9 processor with Xilinx 7-series Field Programmable Gate Array (FPGA) logic. When coupled with the rich set of multimedia and connectivity peripherals available on the ZYBO, the Zynq Z-7010 can host a whole system design. The on-board memories, video and audio I/O, dual-role USB, Ethernet, and SD slot will have your design up-and-ready with no additional hardware needed. Additionally, six Pmod ports are available to put any design on an easy growth path.



Tutorials

Example Projects

Additional Resources