Differences

This shows you the differences between two versions of the page.

--- learn:instrumentation:tutorials:openlogger:log-on-boot [2019/10/14 23:11] – Andrew Holzer
+++ learn:instrumentation:tutorials:openlogger:log-on-boot [2019/10/15 18:06] – [Configure the OpenLogger] kaitlyn Franz
@@ Line 10: / Line 10: @@
 <WRAP column half>
-On waveformslive.com, click on the connected OpenLogger to connect to the device and navigate to the //Instrument Panel//. In the control panel to the right, expand the //Advanced// section. Click the Log On Boot toggle to enable it. When enabled, the device will save the current parameters to a file that is read when the OpenLogger boots. In the case of logging to SD, the device will check to see if the SD exists, wait for the SD card file system to initialize and then start logging if all is good.
+On waveformslive.com, click on the connected OpenLogger to connect to the device and navigate to the //Instrument Panel//.
+In the control panel to the right, expand the //Advanced// section.
+Click the Log On Boot toggle to enable it.
+When enabled, the device will save the current parameters to a file that is read when the OpenLogger boots. If set to log to SD, the device will check to see if the SD card exists, wait for the SD card file system to initialize and then start logging if all is good.
 </WRAP>